MCH heaters for soldering tools
Soldering is a thermal recovery test: how fast the tip returns to setpoint after you touch a joint. A low-mass, high-density ceramic element with heat concentrated at the tip wins that test consistently.
Tip-focused heat
By grading the printed circuit along a rod, we put more power at the working end and less in the shaft. That shortens warm-up, improves recovery and keeps the handle cooler.
- Fast warm-up and strong tip recovery
- Graded / localised heating zone
- No exposed resistance wire to oxidise or sag
- Stable resistance over repeated thermal cycles
- Electrically isolated outer surface
Integration options
We can supply the bare element, or the element with brazed electrodes, leads, thermocouple and a tip-mounting interface as a tested assembly — one part number for your production line.
- Ø3–20 mm rod / tube formats
- 12 / 24 / 110 / 220 V variants
- Thermocouple or NTC integration
- 100% power and dielectric test
Specifications
Questions buyers ask
Yes. Send the tip drawing or a sample and we will fit the heater length and active zone.
Because the circuit is sealed in ceramic there is no oxidation-driven resistance drift, which is the main failure mode of wire-wound elements in this duty.
Get a soldering element
Tip geometry, voltage, power, setpoint and recovery target — we will propose the element.